Picture a bowl full of washing-up water. A control on the sink deck opens the waste without having to reach down for the basket strainer. When choosing its position, think about what stands on the drainer after a meal.
01
Identify which bowl it controls
On a drawing of a double sink, mark which bowl you fill and which you use for rinsing. Ask which waste the control operates and how the other opens. The number of bowls alone cannot tell you.
02
Leave space for your fingers
Put a saucepan on the draining board and imagine the tap in place. Can you still reach the control? The Deante Evora ZQJ_N11A specification lists two existing holes and no extra pre-drilled positions.
03
Check the whole waste kit
If you are replacing the waste alone, note the sink material, outlet diameter and overflow shape. Compare these with the kit specification and check the route of the control mechanism under the deck.
04
Try it in use
At handover, open and close the waste from above. With the installer, confirm that the bowl holds water, drains when released and leaves the storage below clear.
Before you decide
- Identify the bowl to be controlled.
- Locate the available holes.
- Match the waste, overflow and mechanism.
The essentials
Your questions, our guidance.
Is a pre-drilled position always ready to use?
It marks a prepared location. Check the sink drawing to see whether it is already open and what the manufacturer specifies.
From idea to project
Discover at EDIFIS
Choose between one and two bowlsMeasure an existing sink cut-outConfirm references, configurations, finishes and availability for your project.
Documentation & references
EDIFIS design advice. For specifications and installation, consult the documentation for the selected reference.
Deante · Evora sink technical details ↗



