You reach for the bin with a handful of peelings, but the drawer barely opens and the bucket catches on the bowl. A side view of the cabinet can reveal the problem before you order.
01
Find the lowest point
Measure the cabinet between its inside walls. On your sketch, mark the underside of the bowl, the waste fitting, the trap and the pipe runs. An offset trap takes up most of its space on one side.
02
Draw the full drawer travel
Draw the bins with the drawer closed and open. Check that the top edges clear the bowl and that there is room in front of the cabinet to lift out a full bucket with both hands.
03
Match bin sizes to your habits
Notice what you throw away over a few meals. If you flatten cardboard elsewhere and take peelings out every evening, a small bucket that is easy to carry may be the better choice.
04
Leave the trap within reach
The compartments on the BLANCO SELECT II 60/3 Orga can be moved to make room for drain fittings. In your own layout, practise removing a bin, then reaching the trap.
Before you decide
- Measure between the inside walls.
- Test the drawer with a bin in place.
- Find the access point to the trap.
The essentials
Your questions, our guidance.
Can I choose bins from the stated cabinet width alone?
Rail depth and clearance under the bowl matter too. Check both against the dimensioned drawing for the system you have chosen.
From idea to project
Discover at EDIFIS
Leave room for the pull-out spray hoseInspect the trap beneath your sinkConfirm references, configurations, finishes and availability for your project.
Documentation & references
EDIFIS design advice. For specifications and installation, consult the documentation for the selected reference.
BLANCO · SELECT II 60/3 Orga technical data sheet ↗



